Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have begun to sue 1811, 12.4(6)T11.I cannot access SDM from outside of the network. Client computers in the network can connect internet. Interestingly, when I try this from the network, it works.http://globa_ip_on_fe0_of_router/But, this does not ...
Some buttons in SDM began to stop working."Additional Task" does not show any contents. Edit button on a certain page does not work. I think I stalled it on the router.I reinstalled java script, but it did not solve it. Should I just run the installa...
This sounds very basic question, but I could not figure out whole day...1811 / 12.4(6)T11Our new ISP gave us IP adress block, subnet mask, gateway, and DNS. My home-level router works fine, but I do not know what is missing on 1811.I followed quick s...
Hello. I bought it a couple of days ago, but it suddenly got stuck while I was updating the static IP address. Because I could not login by old and new IP address any more, I tried to reset to the factory default. I am reading this, but I am stuck at...
Hello. I am new to Cisco products and this forum.I bought 1841 for my organization, but I found out that I need to upgrade IOS in order to use Firewall, NAT and VPN.Looks like I need to upgrade IOS. Because I did not buy it through Cisco reps, I coul...
Yes, I have done so. Thank you very much for your help and advices. Although I could solve my first problem, I am sure that I will face another difficulty when I try to do something more advanced.This community is very good.Thank you very much.
Thank you so much for your explanation. This is exactly what I needed to know. My java was latest, 6u16, which was out of support.I will find and install the versions you mentioned above.Thanks again.
FE0 has the IP, the first one out of the block. FE1 (another WAN) is not configured. I made it disabled.I ran the Basic NAT wizard, and the Outside interface is FE0, and the Inside Interface is Vlan1. I did PING from the other network, but it did not...
