Good day everyone,
Is it possible to WECMP based on real consumed bandwidth in MPLS Segment routing environment?
As i understand, based on
explicit-list weight [...]
feature it is possible to unequally load balance but it uses ONLY link bandwidth co...
Hello everyone,
could any one tell me, please, in which YANG model i can check the output of "show policy-map type epbr" information.
I should gather input and output information through NETCONF YANGSUITE.
Thank you in advance
Hello everyone,
Could anyone explain me, please, about the difference between Egress and Ingress PCC. While reading RFC about the PCEP protocol can't catch the real meaning of these two terminologies.
Thank you in advance!
Good day everyone,
I am interested in Segment Routing WECMP. I've searched about load balancing in Segment Routing and found that there is a formula by which load balancing calculates. But i didn't find the logic that on which information it load bal...
Hi everyone,
I want to upload the startup-config to real router via tftpd64 in vmware windows server.
Windows server and ESR6300 are under the same network. But ESR6300 can ping windows server only from mgmt vrf.
Through global router ESR6300 can'...
Good day @Harold Ritter , Thank you for your response
Does IOS-XE work based on the same logic? I'm using specifically ESR6300 IOS-XE(17.09.5a) and c8000v IOS-XE(17.09.5a).
I've tried configure the commands that explained there but i guess it doesn't...
Good day @Harold Ritter
I've been searching the document about the WECMP load balancing criteria but couldn't find. We're going to try configure Segment Routing WECMP packets by various components .
Could you share, please, the document, if you hav...
