Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have many spokes that will connect to a hub site,and won't fit in a router if using one GRE tunnel for each remote. Won't have IPsec. Plan to use DMVPN to allow only one router to handle all the tunnels. Is it possible to use Dynamic Multipoint VPN u...
Hi Have a 7500 that will be used to extend MPLS network to a remote side. I´d like to know if I can run the MPLS link, using LDP, over a port of the FSIP8 module. Are there any restrictions for MPLS over this module? Also, I´d like to know if the FS...
I found in Cisco Web site a document called "Understanding Dial Peers and Call Legs on Cisco IOS Platforms" that clearly tells that this configuration is not supported. Calls originating and terminating on the same router are called "hair-pinning",a...
We also found the same behavior connecting ATAs to a Cisco gateway. When connection comes from IP, and even if there is a dial-peer voip for the called number, the call is not sent to the destination ATA. If this dial-peer is a pots one, the call is ...
Hi, Luis When you say no Qos, you mean it is not possible to configure in the CLI, or you can configure it, but it will not work? How exactly it is not supported?