Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 1760 router with voice (c1700-ipvoicek9-mz.124-15.T11.bin) working fine.I am trying to use a translation rule on one of my FXS ports to redirect all fax calls from that line but it is not working. I want any number called from this line to ...
I currently have a router with a public interface that I want to use as a back door to my network. So if my network were to die I would still be able to get in.The router is a 2811 running an security IOS. Is there a Cisco client that will allow me...
I currently have two sites A and B that can 'talk' to each other via a hub router. The issue is that I want to stop them from 'seeing' each other as they should be aloud to see the Internet (always) and each other under special circumstances. I kno...
I have three PRI's running onto my router, with around 500 phone numbers on it. If there is a phone number on the PRI from teh telco but no associated DP on the router, then the call takes up all remaining trunks as it searches for a home.The fix fo...
I have two PIX 515's running in failover mode that were just upgraded to ver 8.03 from v 7.11.Ever since the upgrade on Friday the PIX will work fine for about 10-15 hours. Then all of a sudden no one on my network can send mail? I have confirmed t...
The problem with your translation rule and num-exp is that they are too specific. I need to append 200 to all outbound calls from a specific port. The phone number 4033013400 was just an example.DaveFrom original post "I want any number called from...
Basically I have three routers, A, B and C.C is the remote router that I am putting the translation rules on, and has one FXS port on it with an analog phone.A and B are gateway routers, but A is the only one I am trying to work with at the moment. ...
The problem that I am still having is that the called number is not actually being translated when I applie this to the voice-port.I setup an outgoing dial-peer so that any number that begins with 200 goes to a different gateway, but the 200 is not b...
Actually this one I wanted applied to the port not the dial-peer.Here is what I have now and it is working....voice translation-rule 1rule 1 /\(.*\)/ /200\1/voice translation-profile testytranslate called 1voice-port 0/0translation-profile incoming t...
