Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are about to implement QOS on our WAN and are considering upgrading our older routers to the 1841 model. The current routers run the ipbase image but my supplier says that an 1841 with ipbase does not support some QOS functionality. What is the ...
I'm a little puzzled here, I have a guy with a brand new laptop that can't pick up a dhcp address from the Cisco router but he can if he plugs into his little wireless network router. I had him take another machine on the Cisco network and do a rele...
I would like to be able to use an SSH client to connect to my PIX firewall over the Internet. I can do this to my 506 PIX but not on my 515, with debug SSH on I keep seeing "invalid userid michael" even though I have put the command "user michael pa...
It's a spare that was sitting by my desk; I had been in it previously and can't understand why now I cannot get a proper console session going with 9600, 8,n,1 even though this console setup works perfectly when I plug the connector into a spare swit...
Thanks for your reply. Sorry, what the supplier actually said was that ipbase supports 'some' QOS functionality, which lead me to wonder what functionality I was missing out on. We are running VOIP between our branches and just want it to work well,...
He tried it from 2 different ports, the ethernet port on his phone and a wall jack which goes to the switch directly. At any rate, we eventually decided to try rebooting the router and that fixed everything.
Well I finally got into the router. I managed to connect at 115200, changed the config register and got in and found the password and then changed the config register back - at which point the router needed to be reset so I powered it off and on. I...
Thanks Rick, yes I agree with everything you said and I have tried a few different speeds and other parameters. However unless I can see what's happening on the console I cannot interupt the router or get to the point where I can change the password...
The PIX and the 1721 are on the same LAN as the printer but the PIX is not in between the router/printer.I did manage yesterday (monday) to get the remote terminal servers talking to the printer; it looks like it may have been a default gateway issue...
