Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If I want to connect a Cisco Fibre 1 gig SFP port to a simple Netgear FSP port will it work?The above works when i use a CAT 5 connection.Many thanks.Mike
"Port cost comes into picture when closest path to the root bridge has to be decided."If you want to tell spanning tree to use a certain port, what do you change. the port cost or the priority. What does the priority do?What does the port cost do?Man...
Spanning tree selects the route bridge by looking at the Priority and the Mac address?Spanning tree also looks at the Priority of a port and Mac address to select the Root port, blocked port etc.Where does the port cost come into it?10meg = 100, 100 ...
Hi,I have two 6500 cats sitting as the core of my network, linked by a 3 gig ether channel. These are working fine.I am introducing two new 6500's to my network to create a square backbone. But at present I am using these two new 6500's as simple dum...
Hi,3750, 24 port gigabyte swtich with 4 SFP's. It currently has one fibre FSP in it which is working fine.WE just went to put a copper SFP in it and it would not work "Error disabled" We tried 3 different copper SFP's in all and they all created the ...
There are no access lists configured."Can u verify weather the management vlan is allowed on this ether-channel"I do not know if the managment Vlan is allowed on this ether channel!! What would the command be to allow it? Do i need to wright a comman...
If Microsoft took over Apple, windows xp would probably not fit straight onto macs, there may have to be a hard where revision before windows xp would run on a Mac.The same case with catos and ios, cisco bought out the company that orignally created ...
The two orignal CAT's have routers in them, E.G. the layer 3 routing is done by these.All ip addresses and gateways are in place and set up correctly.This is just a strange one, perhaps the config of the ether channel is incorrect or something
