Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone.Does someone know why can't I access this table?C:\>snmpwalk somehost .1.3.6.1.4.1.9.9.276.1.4no MIB objects contained under subtreeIs there some magic command to enable these variables? Because the router surely understand this OIDsom...
The IOS is a bit bigger then 32M and you use some tiny TFTP server like pumpkin, right? Yeah, that's a well-known problem. TFTP protocol use 512-bytes blocks and use integer to count these blocks. For those files, which are bigger then 32M, TFTP BLOC...
It is possible to influence output presented in sh int with load-interval interface config mode command. However, NMS usualy use ifInOctets/ifOutOctets variables to calculate bandwidth utilization. These values are absolute and depend on sampling fre...
Check the requirements on http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_example09186a00800ef797.shtml#reqSeems like 37xx don't support trunkig and FEC at the same time on the "routed" interfaces. But you don't use any a...
