Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'd like to know how STP failover works in this scenario:Network:2 core switches, direct links between switches. Core1 is primary for vlan 5 and core2 is primary for vlan 10.3 closet switches, connected using uplinkfast to both core switches. 1 devi...
I have a 4700 router with fast ethernet subinterfaces. I'd like to be able to view bandwidth used on these interfaces (5min input rate, 5min output rate). Currently the output for the subinterfaces does not show this. Is it possible to display th...
When I create a vserver with type "any" I am unable to ping the vserver. That is, the following virtual server IP cannot be pinged.vserver xyzvirtual a.b.c.d anyserverfarm xyzinserviceBut the following one can:vserver xyzvirtual a.b.c.d tcp wwwserver...
We just hooked up a IGX 8430 32 slot rackmount chassis. Slots 1-16 work fine and slots 17-32 show up as "empty".When cards are plugged into the lower shelf (slots 17-32) we get ""Empty 31 HW failure" (31 beingthe among the slot we tried)". The SCM ...
We have a pair of IGX 8420s connected over a NTM E1 trunk. Over this trunk several 24-channel UVM connections are routed. Each 24-channel connection uses up approx 700packets/sec using g729ar8v compression. We are trying to switch the E1 trunk to a U...
Your radius server at 30.30.30.2 is not responding to the client at 10.10.10.2. Look for access lists on the router between the 2 networks which prevent radius communications. Alternatively move your radius server to the 10.10.10 network. R
That is correct, the bandwidth is shown on the trunk. However I need the bandwidth on each subinterface. I can do this with mrtg/snmp. However I wanted to see if there was any way to display it from the console.Raja
Dear zhichao:We are trying to do something similar.Could you post your relevant config for the SQLFARM and real servers-- including the probe part? We would appreciate it.ThanksRaja
Thanks for the reply.1) The W6 jumper is removed on the SCM. Also the node boots up as a 8430 and slots 17-32 show to be empty under "dspcds". 2) Cards in the lower shelf do get power. When any front/back card set is plugged in, they go into "fail s...
