About michal-miac

michal-miac · 08-14-2024

Hi, I have a network with one router and two hosts, each in a different subnet. For Host 1 (192.168.1.1) to reach Host 2 (192.168.2.2), it must connect to the router's f1/0 interface IP address with destination port 1234. The router should then forwa...

michal-miac · 05-04-2024

Hi,how to manually enable the R flag (R-bit) in ipv6 config, let us say in a cisco csr1000v?I have this documentation:https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipv6/command/ipv6-cr-book/ipv6-i3.html#wp1103499300but unfortunately I could only ...

michal-miac · 05-03-2024

Hi, how to manually disable/enable the L flag in ipv6 config, let us say in a cisco csr1000v?Cheers,Michal

michal-miac · 03-27-2024

I have a few general questions when it comes to my network. Maybe someone could even suggest how to name the topic of my question. But firstly, I'd like to introduce you to my network. The special thing about the network is that subinterfaces are con...

michal-miac · 08-19-2024

@MHM Cisco World I am getting confused.Why can't you just show me all this config on my topology. I don't understand what you have done before and it does not work for me. If it is so easy for you, then why don't you just do it with my topology. Here...

michal-miac · 08-19-2024

Yes, there is no problem with it, it does not matter if H1 or H2 is on the internet or in your case R1 or R3, but the crucial point here is to combine PAT with port forwarding. @MHM Cisco World let us simplify it, just try to make the project exactly...

michal-miac · 08-19-2024

My dear friend @MHM Cisco World , you want to initiate a connection from R2 with destination address 3.3.3.3, but this is not possible for me! Believe, I cannot do this, because in my real life production R2 is on the internet. This is the reason why...

michal-miac · 08-19-2024

Hi @MHM Cisco World thank you for trying to replicate it in the lab, but unfortunately I have to say that it is not what I am looking for and that this configuration woll not work for me.The two hosts in my case are not routers. They are machines. A...

michal-miac · 08-16-2024

Hi @paul driver which one of these could be left out? # ip nat outside source static tcp 192.168.1.2 1234 192.168.2.2 5678 Start connection sourced by 192.168.1.1 with destination port 1234 and destination ip address 192.168.1.2 on f1/0. Then router ...

Member Since	‎03-27-2024 01:29 AM
Date Last Visited	‎10-16-2024 08:18 AM
Posts	20
Total Helpful Votes Received	3

User Statistics

User Activity

Combine PAT and port forwarding

How to enable R flag (R-bit) in ipv6?

How to enable/disable the L flag in ipv6?

Subinterfaces and VLANs

Re: Combine PAT and port forwarding

Re: Combine PAT and port forwarding

Re: Combine PAT and port forwarding

Re: Combine PAT and port forwarding

Re: Combine PAT and port forwarding