Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone, n00b here.As the title reads, I need help to alow ports 18082 and 18086 inbound to one of my internal servers.I pretty much now how to create a static nat rule but I dont know how to only allow those two ports. I dont want to open th...
Hello everyone, n00b here.We had a cisco tech help us out today so it wasnt I, the n00b, configuring the routers and ASA.So let me explain.We have a domain with 3 childs, all in a Paetec MPLS. One of these childs was taken out of the MPLS today and ...
Hello everyone, n00b here,We have an 1841 running IOS 12.3(8)T5 and need to upgrade to an IOS version that supports vpn.under cisco downloads and i go to products - cisco ios - and then the following are listed:Cisco IOS Software Release 15M&TCisco I...
Hello everyone,disclaimer...n00bOne of our remote offices is going from a multilink (3xT1s) to a single link T1 configuration. The router was originally setup by our network ops guy (who's no longer with us, nor reachable) and we have no idea how to ...
thanks for the reply jcarvaja.to clarify - I will have TWO NAT rules under my NAT Rules section, one for each port configured as stated above.then I will go to my Access Rules and apply those two ports to that outside IP address?I currently have an ...
thanks for your prompt reply.When I select Cisco IOS Software Release 15M&T as the options of IOS's I end up with this one: 15.1.3T(ED). Is that ok? What is the diff with the T's, M's (ED) and other letters in them?Then when I click on 15.1.3T(ED) ...
Rick, thank you for the detailed reply, to answer the Q's; yes, we arekeeping the same ISP, they are just removing two of the T1's and leaving uswith a single T1 using the same IP address.Now for an additional questions that I dont know if the ISP an...
ok, all points taken. seems easy enough to do.sorry but I have a follow up, can we do this before our ISP does the change or can we have this already prepared so when we go to a single T1 the router is already up and running?and what would happen if...
