Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey guys we have a new 4510 that we were upgrading the IOS for and it has a USB port on each supervisor card. The image we were upgrading to was cat4500es8-universalk9.SPA.03.06.03.E.152-2.E3.bin
The USB was formatted to FAT which is what is recomme...
I did some reading and I think it should be fine but I want to see if there is any feedback from the community...
We have two 3750's that are stacked and I want to remove the 2nd one. Both switches are online and running. If I remove the 2nd switch o...
Hello, I am configuring new 48 port 3650 (15.0) and the command in a template is "system mtu routing 1500". I did configure an int vlan but left it shut down with no ip address and that command still did not go through. It seems that command is not a...
I noticed at my job on some of the device configs, they use a loopback address/subnet as the actual area id for OSPF.So instead of your usual OSPF network command like router ospf 201network 192.168.0.0 0.0.255.255 area 0 there is, router ospf 201net...
I can also confirm that this takes about 30-40 minutes, after that the next reboots are normal. The fans are pretty loud and I have the server guys coming up to me complaining lol!
I was upgrading a 3560 from c3560e-universalk9-mz.122-55.SE5 to
c35...
Vlan 1 is native by default, if you specified a diff native vlan on one switch and did not set it on the other then you will have a native vlan mismatch. Can you post your configs so we can take a look?
I agree with Roberto, however I see what your saying about the ACL just as you would a router but for a switch that would only work when passing from one vlan to another vlan, not within a single vlan. Like if traffic went from "int vlan 10" to "int ...
