Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have some access points that were with this message
"Radio reset due to (56) Radio channel set"
They were working with DCA best, after I switched to 20MHz the problem stopped occurring.
this problem only happened with the 5GHz radio.
Has anyone see...
I have a lot of devices with not exist more on my environment and was removed in collector but I still see in the portal.
I made the configuration below but the problem still persists.
Navigate to Application Settings > Report Preferences and enabl...
Hello everyone,I'm having a problem with a flexconnect configuration and would like your opponents.I need to enable the Central DHCP - WLAN Mapping feature, so that users of some remote locations receive the address provided by WLC, but when the clie...
Hi Everyone...
I have a doubt .. I"m migrating some access point from a local where they were using US and TW code country, but in the new locality there is only the active country code BR.
Here comes my doubt
What would be the impact if I did n...
Olá,De uma olhada neste documento.https://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html#88600Ele pode te ajudar um pouco, porque nele contem toda a matrix de compatibilidade, com isso você pode ver por exemplo....
Hi.So, I like to use these configurations.Signal -67 dBmSNR 25 dBData Rate = depends on what kind of application that you will use.One characteristic of the most part the warehouses is, to use a directional antenna.
HiI made some test and I would like to share that information with you.I changed my RF Profile 5GHz / RRM / DCA of Best to 20Mhz and after that works fine.one thing it's strange that before the upgrade version of the WLC to 8.5.151.0 these problems ...
