Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I have at my lab a Cisco PIX 515e (failover) and it boot every 24 hours. The strange thing is every time it boots (automatic or forced one) it misses the remote access via ssh, and I have to go to the console and re-enter the "cry key gen rs...
I am having trouble to configure a c1721 with a WIC 1ADSL card.Actually, I have a Cisco c827 working fine, but when I put the same configuration on the c1721, I am getting the message "01:40:23: Di1 DDR: Cannot place call, no dialer string set"If I p...
Hi There!I have created a VPN group (PIX v8.0(3))to the corporate iPhones, they work fine if the authentication is LOCAL, but if I request them to authenticate within ACS, it fails. What should I do?
Hi there!I running Yate and Asterisk/IAX2 in the same box, to get H323 and convert to SIP, but I have a costumer that wants to send H323 with codec g723, but it doesn?t work good at all. So, can have H323 and SIP running on the same box like a c3600 ...
Hi Jon,Thanks for your help.This command does exist anymore. I just use the write command, but it doesn't save the generated key at all. Anything else that I could do? Thanks again.----MaxiFire(config)# ca save allWARNING: the 'ca' command syntax has...
Hi Giuseppe Thanks for your help!Well I have changed as you asked for but it's still the same.Thanks again,Jonas-------------------------->Maxirede-via-GVT#sh debPPP: PPP authentication debugging is on PPP protocol negotiation debugging is onshut00...
This group has access via remote VPN and via iPhone. Here is mu configuration:object-group network Painel network-object 172.30.23.0 255.255.255.0!access-list Outside_cryptomap extended permit ip any object-group Painel access-list Corp_NAT_0_out e...
