Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know how to enable management of the WLC from a network which is WLAN enabled?By default this is not possible but I was told that there is a way to enable this on the controller.
I have a WLAN deployment with around 40 APs and dual WLC4400's. For some reason the clients seem too "sticky" to their first associated AP and don't roam. How can the system be tuned to make them roam to other AP's better?
After testing today they appear to be roaming and working as they should. This post is the one re: disabling the rates below 11mb/s are what I believe to have fixed the issue.Further review of the M100 revealed that they are CCX v1 compliant...not v...
Not yet. I have only been communicating remotely. I will be on site tomorrow. Do you feel that the issues are more related to the wireless client (M100) than the infrastructure?
The clients are using a Ralink Wireless LAN Card V2 for their wireless adapter. They don't have any form of roaming settings like the Intel drivers do.
