Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There are 8 AIR-AP-2802I-B-K9 access points at one of our remote offices. Two of the APs are showing with 5GHz or 2.4GHz as down, down on the heat map in Prime. All other APs are showing both 5GHz and 2.4GHz as up, up. Why would these be showing down...
Looking for some help with the error messages below. This is for a AIR-CAP3602I-A-K9.*Jan 14 15:28:59.779: %CAPWAP-3-ERRORLOG: Warning, DTLS Sec Engine is overloading, ignore data-Keepalive timeout *Jan 14 15:28:59.779: %CAPWAP-3-ERRORLOG: Warning, D...
We have a Cisco 2851 router that crashes every night. Below is the 'show log' output. The provider is telling us that it is our equipment. We have replaced the router and still have the same problem. Is it our equipment or the provider? Please help.F...
Thanks for the reply. This is a remote router in PR, so we don't have a lot of information. Below are the answers.- does the router crash right after the serial goes down? I wouldn't say it is a 'crash' per say. The serial goes down and we lose con...
I have only used ISL and dot1q. It is really your preference. Just make sure both sides have the same ecapsulation. Try the link below. Hope it helps.http://www.cisco.com/en/US/partner/products/hw/switches/ps708/products_configuration_guide_chapter09...
use the command below:set trunk 1/1 on (isl,dot1q,dot10,lane,negotiate)not sure what encapsulation you are using. that is why i listed them. this will allow for all Vlans to be passed on the trunk.
