Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How can I deny access to specific websites using acl on a router with NAT with overload enabled? DNS and name server are enabled.Currently I have interface FastEthernet0/1 description connected to Internet ip address 192.168.1.80 255.255.255.0 no ip ...
HelloHelp with 2948G _ I am unable to ping the gateway. VTP has no entries in config. the config is as followsThanks in AdvanceMatt#version 8.3(2)GLX upload ! !#frame distribution methodset port channel all distribution mac both!#ipset inter...
The mode you are looking for is multi-auth. Not all switches support - the higher end switches do. I remember it was supported on 3750build 12.2(50) S.E and later.http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_50_se/c...
Hello Dan,If you know the mac address of the NIC on the host. Try show mac-address-table address - it should display or show mac-address-table interfaceThanksMat
I think this is because credentials are cached. To test the theory 1) Wait for a while arbitrary interval say > 10 minutes and retry. It should fail if you try to use the old credentials.2) Reboot switch. Retry it should not allow.
All what you mentioned are required. You should be able to telnet based on ip address on the switch/router belonging to any vlan - assuming we have routing between vlans either via a one arm router or an L3 switch.Here is a sample config.ip dhcp excl...
