About gurkamal01

gurkamal01 · 08-27-2011

Hello ProsI am trying to set up a cisco 6504 with dual sups for redundancy so that if one SUP fails the other picks up the operation.I have placed the Sups in mod 1 and mod 2. Also the IOS for both the Sups is sitting in disk0: of each SUP and both I...

gurkamal01 · 01-11-2011

HiCan anyone tell me why /19 and smaller prefixes have less routing tables than /20, /21, .... for classCThis is done with major Tier 1 ISP'sWill appreciate an responseRegards

gurkamal01 · 12-15-2010

HiI have stange issue on my network.I can ping my closet switch from distribution switch without any problems and vice versa. All are on Layer 3 boundry.Distro switches s is tied into the coreCloset switches are configured as stub and Distro switch ...

gurkamal01 · 10-15-2010

Hi all,I want to monitor the rxload and input rate on interfaces but I can't find the correct OID can someone help me with this please.Can someone also provideme a good document for thisGigabitEthernet4/8 is up, line protocol is up (connected) Hardw...

gurkamal01 · 09-23-2010

HI ,please excuse me for this simple questionOne of my ASA (5550 series) box died but luckly i had all my contexts configuration saved on a Flash card.Q1.Can anybody provide me the steps to restore the saved context configurations to my new ASA (55...

gurkamal01 · 08-27-2011

HiWe have SPA module(for VPN) in slot 3 so i have fpd.pkg also in disk0: i dont know if this could be the reason for the secondary SUP going into rommon mode but the same is true for the primary SUP as it also this file in disk0: and it boots perfect...

gurkamal01 · 08-27-2011

Rezai already tried this and as i mentioned in my first post it works fine but as soon as reboot the switch again i encounter the same issue so this is temporary fix.How can i resolve this issue permanantlywhen i do a show redundancyBoth Sups operat...

gurkamal01 · 08-27-2011

Thanks RezaBoth disk0: are compact flash and have the exactly same image.i cannot load the image is the sup-bootflash as the image is too large so the only way is through disk0:The issue is when i power the switch with both SUPs the secondary comes ...

gurkamal01 · 01-11-2011

Thank for the responseAs per your reply you stated ....." 4 * 8= 32 to represent one /19 and 2 /20s ie. 2 * 16 = 32 to represent one /19".Can you please tell me how we got the 8 and 16 for /21 and /20 respectively

gurkamal01 · 10-29-2010

Hi Derek,Can you send me any cisco document link for this, it will help dig out some information from it.I will really appreciate your helpThanks

Member Since	‎02-19-2008 09:06 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	178

User Statistics

User Activity

Dual Sup 720 3B Rommon issue

CIDR help

traceroute issue

Need OID for rxload and input rate

Restoring context configuration on ASA

Dual Sup 720 3B Rommon issue

Dual Sup 720 3B Rommon issue

Dual Sup 720 3B Rommon issue

Re: CIDR help

Re: Need OID for rxload and input rate