Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the similar problem with configuration group. It was pushed when device was in state that couldn't pull and apply the configuration and the task got stuck. I was able to clear it successfully following this guide:https://www.cisco.com/c/en/us/...
Hello everyone,Is it possible to have a mandatory IOS-XE upgrade on WAN edges (ISR1K series) once they establish DTLS with controllers for the first time after PnP redirection and only then push the configuration group templates?I'm trying to streaml...
Hello.I have set up two IPsec VTI tunnels to AWS with equal cost routing and need to somehow utilize both links for egress traffic. As CEF inserts tunnel interfaces as point2point into its adjacency table and subsequently uses actual physical interfa...
Hello everyone,I'm setting up SD-WAN environment that will be totally on prem, where edge routers have no Internet access. Each ASR1k cEdge device will have two MPLS transport links to reach controllers and several 8300s as hubs. DHCP will be under m...
I was able to find solution. If anyone comes across the same requirement:https://www.cisco.com/c/en/us/td/docs/routers/sdwan/configuration/Monitor-And-Maintain/monitor-maintain-book/remote-server-support-for-software-upgrades-using-ztp.html#Cisco_Con...
After assessing the network environment of this router, I made a decision to give tunnel algorithm a try and it solved my problem.With default universal algorithm:https://i.imgur.com/ZTBqEV7.pngWith tunnel algorithm enabled:https://i.imgur.com/LwcZ1q...
This router is pretty much border BGP box, which unfortunately has to handle several high bandwidth cloud VPN tunnels as well and as multipath is globally enabled in BGP process, regular L3 traffic also traverses via ECMP in some critical segments, s...
There are two L3 routed links between cEdges and HQ. DHCP relay (helper-address) to our DHCP server IP is configured for our MPLS L3 termination interfaces by ISPs, so DHCP will be entirely under my control. That PNP guide requires cEdge to have Inte...
I didn't know IOS-XE supports ZTP as well, thanks for pointing this out! All the routers will connect via redundant MPLS VPNs and have IP reachability to controllers' subnet so NAT won't be needed.We have enterprise CA (MS ADCS), I guess our PKI will...
