Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have built an ASAv in AWS and I keep losing connectivity. It is built per this document: https://www.cisco.com/c/en/us/td/docs/security/asa/asa96/asav/quick-start-book/asav-96-qsg/asav-aws.html It loses connectivity to the management interface firs...
I'm doing an SD-WAN lab with controllers onsite. vManage, vSmart and vBond are all communicating. I manually added the first ISR 4431 router to the PNP portal. It show "pending redirection". In vMange, I sync the smart account. It shows success and...
I am labbing up SD-WAN using my Enterprise CA. The installation of my root cert doesn't show up despite showing successful when installing via the GUI and CLI. I even found reference to syncing the root cert chain by going here:https://<vmanage ip>...
I need to configure my management interfaces for out-of-band. Do I need to put them in a vrf? The config guide doesn't mention it but is very cryptic. It also says to put a static route (BUT IT'S NOT UNDER A VRF???) That could potentially break rout...
Monitoring shows very little usage. See attachment. I noticed this happens when using ASDM. I have restarted the instance and used only CLI since. It has been stable over an hour and I have one Anyconnect VPN connected for that long as well.
This is not solved. I have the same issue and I am on the latest code from AWS. 9.15(1)15. I have rebuilt in AWS many times to no avail. There is obviously an issue with ASAv in AWS that is not resolved. Cisco needs to quit defaulting to telling peop...
Issue was resolved. It was my controllers were at 18.3.5 and they don't support ISR44xx routers. They do support ISR43xx routers, just not 44xx. I tried upgrading but the file copy kept failing. It's progress bar showed 100% but then got stuck in "c...
"show sdwan control local-properties" shows the same serial # and certificate serial # as the command I used. Where (and why) do I need to add the processor board ID? The PNP portal asks for serial #, Base PID, and Certificate serial #. This doc doe...
