Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having a problem with a CSS 11506 internittently locking up when I try to access it via telnet or console. I have a second CSS in a different location that does not have this problem. The active software version on both CSSs is SG0750103. I ha...
Recently I have been logging the following error messages on my CSM:Oct 17 14:17:02.277 CST: %CSM_SLB-6-RSERVERSTATE: Module 4 server state changed: server x.x.x.x:443 in serverfarm 'WEB_SEAL2' has reached configured inband health retriesOct 17 14:1...
I'm using a PIX 515 with IOS version 7.0(4) and a websense filtering server. Everything works fine until the server is taken offline for maintenance. When the server is replaced I have to re-create the url-filtering commands on the PIX in order for t...
I have an interesting problem. I have a VIP with a two server, serverfarm. Originally the VIP and serverfarm were doing load balancing in the switch IOS and the vip was configured with a 27 bit subnet mask. I moved the configuration to our csm mod a...
What type of laptops are these? With Dell laptops and the wireless adapter you also get to set band preference if you allow the Dell Wireless Utility to handle the laptop wireless.
Actually there are only two MAC addresses registered. It looks like one mac is registering in two vlans. You have voice vlan 3 and data vlan 20 configured on this port and the port is not configured as a trunk. Try configuring the port as a trunk a...
I had a similar issue with a 3550 switch. I opened a TAC case and was told to remove the MLS entries. Unfortunately I changed jobs before this could get implemented.
Those are the only ways to upload the cert.Use this guide: http://www.cisco.com/en/US/products/hw/contnetw/ps792/products_configuration_guide_chapter09186a0080579eab.html#wp1000375
In that case the collisions would be caused by a bad nic or cable. Have you tried replacing the cable or nic? You could also try moving the connection to a \different port on your switch to eliminate the port as the problem.
