I am attempting to setup a config on a Pix 501 with Cisco VPN Client. I can get connected (authenticated) remotely with Cisco VPN Client, however I cannot seem to get any traffic to the remote LAN. When I look at the statistics in the VPN client the ...

I will be changing the public IP of the outside interface on my ASA 5510 (8.0(3). I have an IP Sec connection profile setup with users accessing our LAN remotely with Cisco VPN client. The connection profile uses a shared secret that is not changing,...

Not sure if this should be in the LAN or WAN section, but here it goes....I have setup a Cisco 2801 that I had sitting around in the office to see if I could use it as a alternate gateway for some of my LAN clients to get access to the WWW.I am havin...

On my ASA 5510 we currently have a single "outside" connection to the Internet. I would like to add an additional connection using the interface ethernet 0/2 using a DSL line already installed in the office. Is it possible to route all http traffic t...

I have a 2950 switch and I want to block or drop all ip traffic on port 368. All of the ports are all on a single VLAN (eg VLAN 40). What is most efficient way to do this? VACL? If you could provide an example of the appropriate commands that would...