Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
224.0.0.2 is the all routers multicast address. You should probably investigate what that traffic is, because it might be important.Eugene"Don't forget to rate"
Think about it this way:Each switch (or bridge) has one port that is the best path back to the root bridge. That is the root port.On each segment, there is one port that is the best way off of the segment to get to the root bridge. That is the desi...
If your requirement is to use the same IP address for the default gateway, you could use GLBP (Gateway Load Balancing Protocol). Check out the link:http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_white_paper09186a00801541c8.shtmlEuge...
Sure.Take the network 192.168.0.0/24. Let's say I need one subnet of 100 users, one of 50 users, and one of 25 users (I am assuming that I am not expecting any growth).Well, I need three subnets. The /24 will give me 254 hosts on one network. I ca...
