Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are connecting three sites using MPLS Layer3 VPN technology. We are using service provider network for MPLS (core) connectivity. All of our 3 sites are connecting over MP-IBGP and then forwarding Internet traffic to one of PE, which is forwarding ...
I really need an expert opinion on this. What is the difference between these two topologies? Area1-------Area0-------Area1 And Area1-------Area0-------Area2 I understand LSA type 1,2,3 are area specific. Why should I change the Area numbers because ...
I really need an expert opinion on this. What is the difference between these two topologies?Area1-------Area0-------Area1AndArea1-------Area0-------Area2I understand LSA type 1,2,3 are area specific. Why should I change the Area numbers because the ...
I want to use Cisco 3660 for atm aggregation. Like I have two IMA 4 port E1 Port adapter modules, ATM OC3, multimode Port adapter, 1 port and they all comes in the same chassis Cisco 3660. I want to know is it possible with Cisco 3660, Does 3660 supp...
Hi Giuseppe,1. are you receiving an EBGP default route on your CE routers at the other sites ? Yes, traffic is reaching to internet destinations all the way. The only issue is with Internet PE.May you reach the Internet PE interface from your CE rout...
Well,To get the advantages of VTP you need to have one switch acting as VTP server.lets say, you got two switch A and B. lets make Switch A as VTP server and select domain name for the VTP.Swtich-A(config)# vtp mode serverSwtich-A(config)# vtp domain...
In case I just want to use range command feature under ATM configuration. Is it necessary to get 12.2SB. ATM range command feature is an important feature and I would it should not be with specific release.
Forward/Return traces, delay and latency are same as it is for other clients. We had tried to limit our traffic to single STM4 instead of multiple STM4 with OSPF load balancing but results are same.
