Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,I experience packet duplication on my workstation with the Cisco VPN client. My set up is as follows.Windows 2000 Professional SP2VPN 5000 client v.5.1.10 3DESThe packet duplication only occurs when NOT using the client. For example just browsing...
Here is my hardware setupDual C6K 6509 w/SUP2/MSFC2/PFC2Cat6000-sup2cv.6-2-2.binSwitch Fabric Module 216 port GIG-E modules (Shortwave)I have configured an 8 port etherchannel bundle between the two switches, same admin group.I would like to figure o...
Hello Thameem,The ASR supports 802.1q encapsulation on sub-interfaces. It's also possible to create Layer 3 port-channels with the ASR.The sub-interface configuration example is below - interface F0/0/.100 encapsulation X <--- VLAN tag value ip addr...
Just an update,I have a ticket open with Cisco on this issue, but have not heard anything back. They had me upgrade the client through several revisions, with no success.Hope something comes down soon as this is a major pain and interference.jesse
We currently use HSRP across 4 MSFC's in dual 6509's.We use HSRP to balance the ARP handling across the two routers in each switch. IP-helper addresses are enabled on all interfaces as well. The active routing interface is controlled by the active HS...
I would just like to follow up with th same question.I recently heard something to the same effect, but have not been able find docos to support this.It is of special concern to me, as we implemnt NAT/ACL functions on the MSFCThanks in advance for an...
Thanks for the info!I assume you are referring to the first port listed when initially configuring the etherchannel bundle.Is there a way within the switch to verify this, or do I need to use outside tools?
