Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have problem regarding MWI not working when vociemail box have new mail.I have tested maully the DN for MWI on and Off it works but but some one drop a Voice mail message my IP phone havnt show MWI on on my IP phone.Please help me out .---------...
I have successfully established the IPSEC tunnel with juniper firewall by using cisco Pix 501 (6.3 version). The problem I am facing, I have network layer connectivity but after time interval I am not able to send the traffic on destination IP addres...
hi,Any one help me out i have to configre IPs on ASA 5510.where i will put this IPS(inside,outside or DMZ)Gigabit port of ASA SSM 10 module will be used or notplz helpand inform me from basics
hi,I have configured my Voice enable E1 on cisco 2821 using 2 MFT E1 card.i want to use only 6 channels out of 31.for example i use only 6 channels that it is pri-group timeslot 1-6when channel 6 is busy and another call comes in it uses channel 7 b...
yeap.I have add dial-peer in CME with incoming destination pattern command and destination patttern would be like (on and off MWI with three idigit extension number)dial-peer voice 999 voip incoming called-number 80[3-4]... codec g711ulaw no vad
hi,my current scenrio is Devices Port RoleConnected to Ip phone Ip phone+desktop (Vlan 2 voice,Vlan3) Call manager(vlan3) serverDHCP (vlan 3) routerWhen IP phone reboot it havnt able to get ...
