Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello to everibody. I have a network with some autonomous Access Point Aironet 1200, and on every Access Point I have configured 3 SSID and each SSID is associated to one VLAN. For exaple: SSID white --> VLAN 10 --> Radius A SSID red --> VLAN 20 --> ...
Hello to everibody.I have a network with some autonomous Access Point Aironet 1200, and on every Access Point I have configured 3 SSID and each SSID is associated to one VLAN.For exaple:SSID white --> VLAN 10 --> Radius ASSID red --> VLAN 20 --> Radi...
Hi,I am using Location Appliance 2700 Serie, and I must import a plant in WCS.According to "Cisco 2700 Series Wireless Location Appliance - Deployment Guide", the only two importable formats are: .jgps and .bmps.I have a plant in .dwg format.Can some...
Hy, I have a wireless controller 4400 and I am using internal DHCP.I am unable to receive a IP address from the switch connected to the controller.Thr debug messages are:DHCP Op: BOOTREQUEST(1), IP len: 300, switchport: 1, encap: 0xec00Tue Sep 5 08:...
Thanks a lot...So I am using GUI interface of controller in the task Controller--> Internal DHCP SERVER.In this task I am unable to bind the DHCP scope to the management interface
In my configuration, I use "bridge-groupe 1" under the four subinterfaces Dot11Radio.Do you think that this configuration is correct? interface Dot11Radio0.1 encapsulation dot1Q 1 native no ip route-cache bridge-group 1interface Dot11Radio0.10 encaps...
Hi,I Know that a good choises for Cisco devices are:- Cable LMR 600 100 - 150 foot (4.4 - 6.6 dB)- Cable LMR 400 20 -50 foot (1.3 - 3.4dB)For this type of cables you can visit this site: http://www.timesmicrowave.com
