Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, I am running two 1841 routers with a PtP linking them together. I have setup one as an internal clock and the other just to listen, but both interfaces (even though the cable is connected on both ends) is listed as down/down. Even with r...
okay got a question. I am trying to install and use a AP on a 1841 series router, it is HWIC capable, but the interface shows when you show int, but it does not show under show run, nor can you find it and access it through global config, well not t...
Turns out it was a ISP problem. They had the wrong circut id for our records vice what they actually put in so it was not connected properly. Thanks for all your support though! The PtP is up and running now correctly! Thanks again!Kent
No ADTRAN CSU/DSU's around sadly. I have a regular cable running from the port to the demarc. could that be the problem? Should I replace it with another cable with 1-2-4-5 pinouts? If so what is the standard for those pinouts to I can whip up a ...
Okay I will give this a shot, thanks for the help so far! Just to show how fully ignorant I am, the jacks look like an RJ45 jack, but they have different pin outs right? so a standard cat5/6 cable would not work properly correct?
Routers are at separate locations with an ISP involved. Service-module t1 clock source for one is internal the other is not set, Service-module t1 timeslots I have set this command service-module t1 timeslots 1-24 speed 64. all the other commands a...
