What DHCP options are available when configuring IOS as an DHCP server?Where can I find the documentation for the available options?Thanks in Advance.DTA
How do the WS-CAC-6000 power supplies interact with each other and the chassis if one power source is on UPS of each power supply and the other power source is on normal street power? Can a power spike from the non-UPS side carry through onto the oth...
%DSMP-4-WARNING: Warning : NO EVENT-DATA MEMORYNeed explanation of warning.Can anyone help?Cannot find documentation on warning message.Thanks in advance.DTA
Having an issue getting layer 2 between Cisco 2811 and IP Alliance sollution.Layer 2 keeps bouncing.Posting config. from Cisco 2811.controller E1 0/0/0 pri-group timeslots 1-31 service mgcp description DID Range(s): xxxx;xxxx;xxxxinterface Serial0/0/...
Can you run SDM and CME 3.0 both on a Cisco 3640 with internal 64M flash and 128M RAM, plus 20meg external flash card? Plus any configuration documentation would be helpful?Thanks in Advance.DTA
Plz post the config for the router.Make sure you have configured the correct trunk protocol and have configured the native vlan to match the primary vlan with the switch.Hope this helps.
What kind of traffic are you going to support?Are there any servers involved?Are you going to implement any kind of QoS?Most Cisco routers are robust enough to support enough routing on a stick with a single interface.
I have another site where clock source line is working.E1 0/0/0 is up. Applique type is Channelized E1 - balanced No alarms detected. alarm-trigger is not set Version info Firmware: 20070320, FPGA: 20, spm_count = 0 Framing is CRC4, Line Code ...
Do you have a frame-relay switch in between the two routers? If so can you post that frame-relay switch configurations?If not. In the configuration that you have posted. I don't see the command frame-relay switching on either router.