Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Most of the commands in the pix by default are run at privilege level of 15.You can refer to following document for detailshttp://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00800949d6.shtml#privilegecheersSachin
Hi, I think pix 535 with 1 Gb of RAM is sufficient to handle 17MB of streaming data.As it can handle cleartext data upto 1.7 gbps.I hope it helps.Sachin
Hi, Use the command "sh version" .It will give you the ios running on the pix.Also it will display the mac addresses of the ethernet interfaces in the firewall.Kindly let me know if anything else you would like to know.cheersSachin
Hi, For GLBP configration refer to following document.If you still have doubt then let me know.http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a008042fb97.html#wp1048683cheersSachin
