I am using this link to configure ITD service. I am using Sandwitch Deployment mode. on one side of my sandwitch, source IP address load-balance algorithm is being used and on the other side, destination IP address load-balance algorithm.https://www....

i use this doc and make service like uploaded pic with n9khttps://www.cisco.com/c/en/us/td/docs/dcn/nx-os/nexus9000/103x/configuration/itd/cisco-nexus-9000-series-nx-os-intelligent-traffic-director-configuration-guide-103-x/m-configuring-itd.html but...

Description of the problemIn the architecture that can be seen in the figure below, we have two switches of the same type that are connected to each other with a number of links. The links in question are configured as port channels on each switch. A...

Description of the problemIn the architecture that can be seen in the figure below, we have two switches of the same type that are connected to each other with a number of links. The links in question are configured as port channels on each switch. A...

hello i have two cisco l2 switchi set same load balancing algorithm in two switch i send same traffic to two switch its out from port 0 switch 1 and out from port 5 switch 2how to config two switch to get same output from all devicecan help me?