Hi,I am looking to find detail of the below two types of config on an cisco6500 switch.1.no wrr-queue random-detect 2no wrr-queue random-detect 3wrr-queue cos-map 1 3 0wrr-queue cos-map 2 2 4wrr-queue cos-map 3 1 3wrr-queue cos-map 3 2 7wrr-queue cos...
Hi,As per normal conditions, to go in enable mode we type >enable command, and router/switch asks for password. However, what are the possibilites for a router/switch to ask both username and password on enable mode as well.The aaa commands on router...
Hi Netpros,I need to terminate a broadband and a leased line on 1841, for load balancing / failover with NATting.Is it possible, if yes, then how?Thanks & Regards,Sauarbh Garg+919819313892
Hi,1)I want to know what protocols are used by VoIP. 2)When using VoIP with products other than Cisco, those uses Auto Discovery, do they do ARP broadcast or what? How should that broadcast be relayed over the WAN??Thanks & Regards,Saurabh Garg+91981...
Hi,An IP packet when encapsulated in the tunnel, you have two types of headers - pre-tunnel header and the post-tunnel header. If you don't apply QoS to your tunnel, then the physical interface QoS parameters get copied into the tunneled header.Thus,...
Hi,When you do sla icmp-echo, you are providing the source-interface as dialer., Could you also try providing the source IP address (as your LAN interface) of that icmp-echo.HTH
Hi,I believe the communication between your tftp server, and switch is fine; as the error states that the device is facing problem in openeing the config.So do the following:1. Check if your file has any extension attached to it or not. On windows ex...
Hi,Here are some suggestions:1. Rename your destribution switches, as core switches. A 2-tier architecture looks good for your setup.2. Servers should ideally be connected via a firewall on the DMZ interface. The setup becomes more essential if your ...