Hi,
I have non cisco device , the bandwidth overtime shows 4Mbps and the burst bandwidth shows 100Mbps.there might be an issue with the device or its normal ?
Thanks
Hi,
The call is not going , isdn is up .There are two errors in the trace .
Call Entry(Responsed=TRUE, Disconnect Cause=34)
008768: May 21 14:42:42.644: %VOICE_IEC-3-GW: H323: Internal Error (H323 Interworking Error): IEC=1.1.127.5.21.0 on callID 2...
,
Hi,
I am getting the duplicate error , so entered the following command . "ip device tracking probe delay 10".
It did not solve the problem .So where should i enter the command ,on distribution or access . ?
The connection between Dist and acc...
Hi
Few question is if I use multiuse csr and get certificate from an external CA like godaddy,Can I use it for eap authentication or it need from internal ca .
If I create csr for external CA ( multiuse ), Is it necessary to bind EAP or I can create ...
Hi,
This is a vc device , When It is on call to remote device through internet , there was a lot of delay . My internet speed is only 25Mbps .
So I was assuming the microbursts was causing an issue .
" you've set qos for what though the Ip address...
Hi,
The output i genrated from riverbed steelcentral .
" usually you apply it where the layer 3 qos is at the wan level ".
Traffic captured during the communication between two devices in lan .
where you see the burst or are you seeing it somewh...
Hi,
Is there any reason for these burst .
The device is connected to access switch
access switch-- distribution---core --fw-interent router --isp
So where do I apply qos policing
Thanks