Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllVery weird problem here,My UC500 unit powered off (loss of power), when it came back up none of my ip phones are able to get ip, config or register properly.I tried resoring my config (in case config was wrong), but that didn't help and in the ...
Hi AllI've managed to establish a VPN with another cisco device and can successfully ping a pc on remote end but only if i use command like :ping 3.0.3.242 source 192.168.6.254if i try just a ping from router - no luckif i try to ping from PC on lan ...
Hi AllWe are using uc500 with unity express. We run 3 small businesses out of one office and would like to be able to answer the phone with the relevent company name i.e. "Good Morning this is ABC Inc.)Problem is all 3 businesses are coming in on the...
Hi AllHow do I configure router (2801) to load balance 2 adsl lines? I'm guessing I need 2 x dialer interfaces? and then I create 2 static routes? Is it as simple as that?We have 2801 with 2 x dsl that we used to bond but ISP is pulling the bonded AD...
Hi AllGetting intermittent failures using a 1760 router with 2 adsl wics.Looks to me line like one of the lines has a noise problem? Perhaps someone could confirm this for me?sh dsl int atm 0/0ATM0/0Alcatel 20150 chipset information AT...
Hi ThereAll phones are attached directly to uc500!Running config attached below (I didn't remove anything as it's only running factory default configuration and it's not attached directly to internet)In fact I have made some progress - on one of the ...
Some more information on this issue:I manually setup one of my phones with a static IP addres, and configured the tftp server etc.Even after that, the phone is not reachable (i.e. it cannot be pinged), and the tftp request never reaches the uc500 (I ...
Hi Jon192.168.6.1 is an internal client - it's one of the servers. Any reason why it shouldn't work? If I use 'ping 3.0.3.242 source 192.168.6.254'it will ping successfully so I presume they are allowing ping through at remote end.To clear the tunnel...
Hi JonHey no problem - glad we know that was correct anyway!I've changed acl 114 back to permit ip 192.168.6.x etc.turned on debug and tried to ping both from router and then from client 192.168.6.1debugs attached.RegardsAnthony
