Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 4506's and a 3845 MPLS router. I'm attaching the diagram. I'm trying to figure out why when I do a traceroute from a remote site it is going to the 10.1.1.5 to the 10.1.1.4.Here's the EIGRP info for one of our networks.Routing entry for 10...
I have 2 4506's are Port Channeled. Today my 3845 is only connect to one of those. I'd like to use HSRP and connect the 3845 to both 4506's, that way my MPLS traffic won't have to traverse the first one to reach it's destination.Is this possible? ...
We have a few site to site VPN connections with 5505's. Is there any way to setup a redundant config incase the first one goes down it would reestablish to a second firewall with a different ISP? I am using 5520's at both ISP's.
I've inherited a MPLS network and haven't used it before. On the MPLS router that is in my Home Office there is only one interface. Should that be setup with sub interfaces for each site or am I confusing Frame Relay with it?So for example the curr...
I wanted to see if anyone was currently running iSCSI and VMWare how you had your network configured in regards to the iSCSI traffic. We are getting ready to put in a couple servers on a new iSCSI array hooked to 2 Cisco 3750G's and I wanted to iso...
I was able to get this working like a champ through Wi-Fi any one have any issues getting it to connect through an ASA? I can't get it to connect.Thanks,Gates
