Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I find the limits of various parameters for CallManager v4.0.x. I have searched Cisco's website and I cannot find the answers to the following questions.1) Maximum Number of Paging Zones?2) Maximum Number of Directory Numbers per Paging Zone?3) Maxi...
After you install the CDR Analysis and Reporting (CAR)for CCM v3.3(2), what is the initial administrator account and password to log into CAR to plug system wide reports?I can login now and pull a report for the user I have logged in as. But I canno...
I have a CCM Publisher and Subscriber. I have enabled the two CDR flags: CDR Enabled Flag and Call Diagnostic Enabled on the Publisher. Do I also need to turn those flags on for the Subscriber? In general, the CDR's are only stored on the Publisher...
Try putting these into your dial peer. I had to do that on a CME install that I did.progress_ind setup enable 3 progress_ind alert enable 8 progress_ind progress enable 8David Blair
First, only CCM v3.1(4b) can be upgraded to v3.3 or higher. I have not install CCM v4.0. Since v3.1.x used SQL 7 and V3.3.x uses SQL 2000 you must do a clean install and restore the database.Second, unless you need features in CCM 4.x I would upgrade...
Not to be mean, but how does that apply to this thread? None of us had forgotten our passwords. I fresh installed a CCM 3.3.3 server and installed CAR and could not logon because CCM 3.3.3 did not load the Name Pipes protocol. I had the same probl...
I forgot to mention that CAR and ART require Named Pipes to be loaded to talk to the SQL database. The TAC also talked me though checking the various internal user accounts and reseting those passwords to their default.
