Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know the list of file extensions used by CSPC to do the inventory upload and software update downloads? I have to request an exemption to allow these extensions through our web security gateway. Also, does anyone know if CSPC does cert pi...
Hello Community, Hopefully, I am not the only one that has run into this. I am trying to initialize our AP1800S wireless sensors to find DNA Center. I am following Cisco's 1800S Deployment Guide and not having any luck. For certain reasons, we cannot...
We recently started moving our devices back to TACACS authentication from RADIUS. We had this on ACS, but when we migrated to ISE it only supported RADIUS at the time. Now that we can do authorization sets again, I am curious as to what command sets ...
I ran the GUI update to the lastest version last night and all went well. However this morning I was told server alerts were going off since they could no longer get a ping response from the server. I logged into the admin user of the CLI and I can s...
I see the workaround listed, and I understand that a table has to have some values set to null. Does anyone know where in Cisco Prime this is done? I cannot seem to find it and the command does not seem valid within the shell access of Prime.
Hello Mike, Unfortunately, I already have DHCP option 43 configured for something else on our network, so I cannot use that method. Instead, I need to use the conditional DHCP option 43 which is triggered when the wireless sensor sends DHCP option 60...
Thanks for sharing this link. I do understand how to set this up, but I'm just looking for some command sets others have used for roles such as these. I did not see that type of examples in the document link outside of 'show'. Example:Junior AdminPer...
I feel your pain on this. We have a strict security policy in place that limits the number of devices that can talk directly to the internet. Using the on-prem server is vital to staying compliant and still maintaining active registrations for our li...
I am having the same issue. Even went to version 7 which is now call Smart Software Manager On-Prem, but the issue remains. Anyone from Cisco able to chime in?
