This is probably a simple/stupid question, but I can't seem to find the answer in the reference materials. I have a Catalyst 2924M-XL-A (2U, 24 port, 10/100, with the two big slots in front). When I power it up, all the LED's (ports, SYSTEM, RPS, 1...

This is probably a simple question, but I'm relatively new to Cisco routers. I know my way around interface configurations and ACL's, but that's about it.I've got a 1720 running 12.3 with the full features set (IP ADSL FW IDS PLUS IPSEC 3DES) - the ...

In the process of hardening my router and network I've shut down all configuration ports except the serial console. This effectively eliminates my ability to configure my router from the outside. However, is there any way that I can SSH to the rout...

I"m trying to analyze traffice through a Cisco 1720 so I can finalize the ACL's to protect the network. Ethernet-0 is connected to the DSL modem, Ethernet-1 is connected to the DMZ network and the FastEthernet-0 is connected to the private network. ...

I have a Cisco 1720 router with two WIC-1ENET ethernet cards, one connects to a Cisco 678 DSL modem, one to a perimeter DMZ network and the built-in FastEthernet port to the private network. I did have a WIC-1ADSL card but found out it couldn't talk ...