Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello experts ! I would like to get some idea or pointer about accessing internet via IPSEC LAN to LAN set up using routers. My IPSEC LAN to LAN set up works as expected but I'm wondering if it is possible Site B's LAN able to access internet via Sit...
Hello all,
Am not sure whether the issue I have now is a well-known bug in IOS or something else. I need to get advice from you all about 'clock timezone' command.
I'm currently working in one of service provider company and having roughly around...
Hi experts,
I'm interested about Cisco's IOS feature on Explicit Congestion Notification (ECN). It says in Cisco websites:
"The TCP Explicit Congestion Notification (ECN) feature provides a method for an intermediate router to notify the end host...
Hello there, I hope someone can advise me on OSPF compatibility between Cisco, Radware Linkproof and Brocade router. Our core network has three network devices as I mentioned earlier. Our core switches are running in VSL mode as well as running OSPF ...
Hello guys,
I need some help and advice on dual gateway on a network (using OSPF) with equal default route to ISP. Based on the network diagram (as attached), I have two data center; each has a single up-link to different ISP. In this case, I'm usin...
Hi Peter,
It works but I didn't get this error messages '*Jan 4 05:52:51.563: %SYS-3-TIMEZONE_INVALID: Invalid timezone name' before. It just shows nothing after I entered the previous command. Hmmmm...
Anyway, thank you very much for your sugges...
Thank you Peter for your explanation. For the sake of understanding better, I think I will see it for myself by configuring ECN with WRED on our router connecting to MPLS cloud. If no expected result from it, then it is true that our MPLS provider ma...
Hello all, Thank you for your advices. I'm really appreciates it. I think the problem arose due to VRRP service running together with OSPF. Previous set up for our both Linkproof unit are using static routing with VRRP. When we moving towards to OSPF...
Hi,None except the flaps. Here some snippets from our Cisco core-switches and Brocade Cisco Neighbor ID Pri State Dead Time Address Interface172.31.255.2 1 FULL/DROTHER 00:00:32 10.10.11.200 Vlan550172.31.255.3...
Hi there ! Thank you for your reply. 172.31.255.4 is actually our Radware Linkproof unit and we have two of them with the other unit using 172.31.255.3. VLAN 550 is where Cisco, Brocade and Radware Linkproof connected to it. The OSPF configuration on...
