Cisco Community
English
Register
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Marcos Hernandez
‎02-27-2021
Collaborator
Expertise: CCIE#8283, Data Center
Recent Badges
Awards
Recent Badges
See all
100 Helpful Vote
150 Accepted Solution
50 Accepted Solution
15 Accepted Solution
1 Accepted Solution
5 Accepted Solution
30 Helpful Vote
600 Helpful Vote
300 Helpful Vote
10 Helpful Vote
Stats
Member since ‎05-26-2005
2580
Posts
983
Helpful
215
Solutions

Re: Change Lan IP Network

Created by in Voice Systems
10-18-2012
10-18-2012
The "match interface" under the route-maps are not required. In fact, you can use just an "ip nat in...

Re: Change Lan IP Network

Created by in Voice Systems
09-27-2012
09-27-2012
No. The router decides on which interface to put the packet for outbound transmission and then NAT k...

Re: Change Lan IP Network

Created by in Voice Systems
09-27-2012
09-27-2012
Give the primary route a lower administrative disctane than teh backup route. Remember to use SLA tr...

Change Lan IP Network

Created by in Voice Systems
09-27-2012
09-27-2012
Routing would fix this. I mean, a routing decision (outbound interface) is made prior to NAT'ing. St...

Change Lan IP Network

Created by in Voice Systems
09-27-2012
09-27-2012
The switchport would still be an access port, so no tagging.Take a look at an article I wrote a whil...

Re: Change Lan IP Network

Created by in Voice Systems
09-27-2012
09-27-2012
Jesse,What you do is create an "Interface Vlan X", where X can be "25" for example. Under that inter...

Re: Integrating the UC500 with the SPA8000 FXS Gateway

Created by in Small Business Support Documents
01-03-2012
01-03-2012
If you decide to use a BVI interface, you must enable IRB on the UC500/IOS device.

Re: Cisco SBCS Smart Productivity Applications Video on Demand (VOD)

Created by in Small Business Support Documents
01-03-2012
01-03-2012
I honestly don't know what happened here. The links to the videos you mention seem to have dissapear...

Ask the Expert: FlexPod Training and Demonstration Resources

Created by in Unified Computing System Discussions
12-09-2011
12-09-2011
Great post Friea. Go FlexPod!Marcos

Ask the Expert: FlexPod Training and Demonstration Resources

Created by in Unified Computing System Discussions
12-09-2011
12-09-2011
Tenaro, I will dig out a document that explains how to set this up. For your reference, it is the or...

Ask the Expert: FlexPod Training and Demonstration Resources

Created by in Unified Computing System Discussions
12-08-2011
12-08-2011
Monica,At this point, all collateral and tools are offered only in English. For comments, questions ...

Ask the Expert: FlexPod Training and Demonstration Resources

Created by in Unified Computing System Discussions
12-08-2011
12-08-2011
Assuming that you asked about direct attach storage to UCS, please see the below Cisco Live presenta...

Ask the Expert: FlexPod Training and Demonstration Resources

Created by in Unified Computing System Discussions
12-08-2011
12-08-2011
Tenaro,Do you mean connecting these two systems WITHOUT a Fibre Channel Switch (Nexus 5K/MDS, etc.)?...

Re: Ask the Expert: FlexPod Training and Demonstration Resources

Created by in Unified Computing System Discussions
12-07-2011
12-07-2011
Hi John,Thanks for your questions. Details on how to prepare for the training, where to obtain the a...

Ask the Expert: FlexPod Training and Demonstration Resources

Created by in Unified Computing System Discussions
12-05-2011
12-05-2011
Hi Sebastian, The answer is YES, multiple trainings can occur at the same time. At this moment, 12 t...
Public Statistics
Date Registered ‎05-26-2005 01:13 PM
Date Last Visited ‎02-27-2021 10:15 PM
Total Messages Posted 2,580
Total Helpful Votes Received 983
Helpful Votes From