Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am facing a strange problem with the AIR-PWRINJ1500-2.At times the injector behaves perfectly fine but once Switched Off & again Powered On, all 3 LEDs, never become stable & blink continuously.Has someone seen such a behavior ? Pls, share. Than...
Greetings!Have problem in the following scenario.Requirement:During office hours if an out side call comes to the reception, play the welcome greeting thereafter provide options to the caller to dial the extension of the subscriber if he knows or hol...
Hi Furqan,I am facing the same problem as you were.We have migrated to CUCM 7.1.2 setup from Nortel. But this kind of behaviour was not observed earlier. Any clues.. Would really apreciate if you could share the resolution for this. Thanks!
Hi Zishan,I am facing the same problem as you were.We have migrated to CUCM 7.1.2 setup from Nortel.But this kind of behaviour was not observed earlier.Any clues..Would really apreciate if you could share the resolution for this.Thanks!
Hi Arani,I have been facing the same problem..If enabling the com port has worked for you, probably it would work for me as well.Can u elaborate how did u enable it, as am not Linux geek.Thanx in advance!!Dinesh
