Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 3 DNAC server nodes. I finalized the conf for the 3 and created the H, A, but after I turn off the devices and turn them on, the attached log error message appears for me using maglev most of them (CrashLoopBackOff)ndp pipelineruntime-taskmgr-...
Dears, I am attempting to join a new node to my existing Cisco DNA Center (Catalyst Center) cluster, but I am blocked by the following error message during the configuration wizard:
"There is another node installation in progress. You must co...
Dears, I have a customer who has an issue with voice between two branches; the WAN link is utilized at peak hours of the day. I need a full QOS conf end-to-end from the access switch to the WAN router Does anyone have a document ...
I have 8 PE routers (ASR 9901 running IOS XR) and need to test reachability using VPLS. Specifically, I want to connect a laptop to an interface on PE-1 and another laptop to an interface on PE-2, then perform a ping test to verify connectivity betwe...
I currently have an ASR 9901 running IOS XR version 7.9.1, and I'm planning to upgrade to version 24.2.2 using a USB drive. My goal is to keep the existing configurations on the router intact during the upgrade.could you send me the steps w...
Cisco IOS XR Software, Version 7.9.21ok i will check with the TACthe router in installations phase so i could reload without MW could you provide me with the command to Reloading RP
thanks for your replaybut what you mean specifically by "what code running,"and kindly find below#admin show alarms briefSun Oct 6 12:25:24.538 UTC
-------------------------------------------------------------------------------Active Alarms----------...
