Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a certificate chain that was issued by an intermediate CA and the certificate chain consists of the router identity certificate, the subordinate ca certificate, and the root ca certificate. The router identity certificate was issued by the sub...
I observed two cisco 3945 routers lose IOS during password recovery. Router was rebooted, break sequence ctrl-break, then boot(instead of reset) issued. The router booted to its existing configuration or password recovery failed and router was power ...
=>Routing Protocol in Question EIGRP.=>Two equal metric routes for destination A(through R1 and R2-SVIs on two upstream 6500s)e.g. Destination A=10.100.100.1R1(SVI 1)=172.16.1.1R2(SVI 2)=172.16.10.1<Show IP Route> excerpt example for the destination ...
Can anyone explain, how to export CM topology map to Visio without losing map integrity. Here are the relevant versions of the programs in question:Cisco Works:1.CM4.0UnlimitedPurchasedNever2.DFM2.0UnlimitedPurchasedNever3.IPM2.6UnlimitedPurchasedNev...
Could someone please provide me with a simplest set of configuration steps to fire up Radius in ACS and 802.1X for dynamic vlan assignment. The objective is to roll out NAC L2 OOB using the 802.1X method for dymamic vlan assignments. If possible show...
I found out the solution. By default only a single certificate will be allowed in a single trustpoint. There is an option for <chain-valication> for a certificate and the default is <chain-validation stop> which means that if you have a subordinate C...
config register was set to confreg 0X2142 first time password recovery was attempted. It took but only after the power cycle(not when I simply typed boot) but by then the IOS images were gone. I found that very disturbing when it happened on two diff...
Jon,The affected Vlans needing Layer 2 connections to the Core are an off-shoot of level 5 switches(access-switches); connected to their area Distro(level 4) switches(single link); the Distro switches are then dually connected to the Cores(level3); t...
