About monkp

monkp · 02-09-2006

I am setting up a multicast application within a particular VLAN. What commands if any are necessary for this to work. IGMP snooping is anabled by default...Does IGMP need to be enabled on the VLAN interface for this to work?Is there a way to view th...

monkp · 07-29-2005

When doing a show inteface - What do Input Errors indicate?

monkp · 02-17-2005

I am having problems connecting pix515 VPN with a non cisco VPN in Germany. the reote logs indicate that I am sending a name rather than my outside address as the peer id. (See excerpt from Germany non Cisco VPN logs)2005:02:17-08:39:59 (none) nash[1...

monkp · 02-15-2005

I am running a pix to pix VPN from NYC to Chiba Japan with no problems. I need to add a 2nd VPN from the same pix in NYC to a non pix VPN in Frankfurt Germany which is not working. I have ben provided with the following information from Germany:IKE:E...

monkp · 11-15-2004

- Show ARP will give me all the mac to ip addresses - Show mac-address-table will give me all the mac to switch ports. - Is there a command that would give me the mac to ip and switchport???? I know I can do this 1 address at a time but that is not v...

monkp · 02-10-2006

The Following command worked ... it enabled IGMP and Multicast on the VLAN Interface and the applcation works. Router-1(config-if)#ip pim sparse-dense-modeThanks for your help

monkp · 02-09-2006

Which would be the preferred method if IGMP querier is availble?Also, You say this is a good idea ...Would multicasting within the VLAN "NOT" work without enabling one of the two methods?Do I need to enable IGMP on the VLAN interface?

monkp · 02-09-2006

prkrishn ... I failed to mention that this is all within the same 6513 switch. This document looks like it applies to VLAN spanning multiple switches.Does IGMP need to be enable on that VLAN Interface?

monkp · 07-29-2005

Ankur, Here is the output from show int ...The only thing incrementing is the input errors but what type of problem does that indicate?JSC-1#sh int gigabitEthernet 11/1GigabitEthernet11/1 is up, line protocol is up (connected) Hardware is C6k 1000M...

monkp · 02-17-2005

Thank you very much ...This did resolve one problem .I still have a problem though ... It seems the remote VPN (non Cisco) is looking for my outside ip address as the peer id but I seem to be sending him my hostname instead. How can I change this? (s...

Member Since	‎05-13-2003 09:19 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	20

User Statistics

User Activity

Multicast within a VLAN

Show Interface Input Errors

Peer ID being sent as "Name" rather than "ip address"

Problems adding 2nd VPN to PIX515

How can I show IP to Switch Port mappings - cisco IOS

Re: Multicast within a VLAN

Re: Multicast within a VLAN

Re: Multicast within a VLAN

Re: Show Interface Input Errors

Re: Problems adding 2nd VPN to PIX515