Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I came across one static route command in the configs and could not able to understand the significant of using the track command at the end of static route command. Also, when I check #show track I get this outputabcd-xyz#show track briefTrack Type ...
Hi experts, We have an issue with sf350 switches. I am trying to configure snmpv3 on sf350 switches to get switch performance metrics in nms server but it failing each time. When I do test credentials in nms program it says failed and snmp not con...
Dear Expert,
We have Cisco ASA 5585 SSP20 Firewalls and we would like to monitor Environmental Sensors in our NMS but it's not fetching the values. With ICMP the reachability works fine but other oids are not working. I have tried to get OIDs from...
Dear Expert,
We have a number of distributor switches that has VSS configured. Many times the VSS stand-by becomes active and switch restarts We would like to know the occurrence of this event by ICMP polling as we have not enabled traps for vsl ...
Hi, I have tried to get logs from Switch and I get this...%SNMP-W-SNMPAUTHFAIL: Access attempted by unauthorized NMS: x.x.x.x.Please note I have entered correct credentials in both in nms and switch. I even tried no auth no priv.As far as snmpwalk is...
Hi Balaji, You are always quick to response and helpful as ever. Thank you for that. Yes, I followed the same doc still no help. When I test the credentials it's failing, oid check and snmp walk is a next thing to do. The issue here is snmpv3 creden...
Thank you for your reply.
I am basically managing NMS. So, configurations and preventing the Dual-Active scenarios our Network Engineer will take care of it. I need to reflect these instances in NMS and that's my task.
For your 1st option,
I ha...
