Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an Express Route setup from Azure to on-prem connected to a Cisco 9200 switch. I have BGP enabled on the switch and the connections are all good. Where I need some help is with keeping the traffic to the Express Route from going out the defaul...
Need a little help. I currently have 2 Cisco 9500's configured in a virtual stack, with one of the ports on sw1 configured as a layer 3 port to route traffic to our FW. What I would like to do is add another port from the 2nd switch that is in the st...
Hope someone can help. I am working on changing the default vlan from 1. The problem I am having is as soon as I remove the IP address from the switch on vlan1, and add it to the new vlan interface, I can no longer ping the gateway from the switch. I...
I am trying to connect an HP Nible SAN with a 4x10GB Ethernet Optical port to a Cisco 9500 C switch using a QSFP to SFP+ converter and using a 10 Meter 10Gb OM3 Multimode Duplex Fiber Optic Cable (50/125) - LC to LC. The ports are showing that the ha...
I have 2 9500 switches and I am trying to connect the 2 together without a stacking cable. I have a 100GB QSFP cable connected to port 32 on each switch, I have a link light between the 2 connections, but I cannot ping from one switch to the other. D...
Thank you! I will give this a try. The connection is going to a 10GB FS switch, so hopefully it wont we an issue. We are going to split out the connections for HA to our FW's.
other than the trunk, there is no additional config.sh run int hu1/0/3Building configuration...Current configuration : 57 bytes!interface HundredGigE1/0/3switchport mode trunk
We are using a Sophos XG as the default router which is connected to the 9500 port 3. Here is the config from the switchport. Could the fact that the access mode vlan is still pointing to 1?WTCPASCORE01#sh int hu1/0/3 switchportName: Hu1/0/3Switchpor...
