Gurus,I'm trying to enable stac compression on an HDLC T1 between a 2621 and 6513. On the 2621 int s0/0 config I issue the "compress stac" command and on the 6513 s3/1/0/9:1 interface I issue the same. The link between the two devices stays up, meani...
Greetings,How could I setup my DFM to alert me when one of the two T1s in a Multilink bundle go down? Right now I only get an alert if both T1s go down (the mu interface address.) I recently had a site in which one of the T1s have been down a week an...
Hello,I get the HTTP Status 500 - Internal Server Error when trying to access the package map for RME. Common Services > Device Update > Resource Manager Essentials.The content of the error message is: type Exception reportmessage Internal Server Err...
Hello all, Trying to update device packages for Ciscoview, but after entering CCO credentials, the browser times out after 5 minutes or so and I end up with a .psu lock file in \CSCOpx. Using LMS 2.6 on a '03 server SP1 box. Any ideas appreciated!
DFM 2.0 won't display DNS name in alerts and activities display. I have DNS configured properly and from the CW server I can ping the device by DNS name. No matter how many times I edit the DCR with every possible combination of "Device Name, Host Na...
Joe our carrier has repaired the smartjack for the downed T1 and it's now up again. But I ran the SNMPWalk as suggested: ifOperStatusRFC1213-MIB::ifOperStatus.1 = INTEGER: up(1)RFC1213-MIB::ifOperStatus.2 = INTEGER: up(1)RFC1213-MIB::ifOperStatus.3 =...
Joe, I verified the device details as suggested and both Serial interfaces managed state is "true" as well as the Mu interface. However s0/1 in that router (a 2621) is currently down/down. No alert in DFM whatsoever. Any other ideas? DFM 3.1.1