Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a WAP200 AP configured with 2 SSID's. The AP is configured to allow the use of repeaters and i have 2 other WAP200's acting as repeaters for each SSID. The WAP200 repeater i have configured to repeat the signal for the 1st SSID works perfect...
I am currently running an E1 from a branch office to our HQ using a VWIC2-2MFT-T1/E1 card at one end and a VWIC2-1MFT-T1/E1 at the other. I am considering upgrading to 4Mb, can these cards handle this data rate and if so what is their maximum data r...
I am planning on rolling out Symantec Backup & Restore v8.5 Server Edition to centrally manage the backups of all our servers. I would like to know if this would cause any issues if installed on our Callmanager server which is running 4.2(3). The se...
I have 2x 2811 routers at a remote hub connected to the network core using GRE tunnels & using HSRP for redundancy. I have recently employed EIGRP in the core which extends over the GRE tunnels to the remote hub routers. The remote hub connects to ...
Hi GiuseppeThanks for replying.The GRE tunnels are using ipsec & keepalives but are only linking our network core to the routers at the remote hub, there are no tunnels from the remote hub over the satellite link to the vessels.On the vessels, the vs...
No we can't connect to the server, i notice this using the sh ip eigrp neigh command, it is probably a blip but it was enough to stop the pings to the router before i added the static route.
