Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi people,I have a CS-MARS and need to send alerts when specific events occurs. Using the action field in the inspection rules, this is achieved without problems.But, I need configure alerts by a most general way, like for events of a specific severi...
Hi person,I have an issue about a Cisco Unified CallManager 5.1.2.1000-11. When updating any information of a device (a phone 7911) and then clicking in "Save" I receive a message box with the following text: "Operation Completes By Date/time must be...
I'm testing a Cisco 3825 Integrated Services Router, but it don't show any output when connecting a rollover cable in console port.I set all available baud rate in my terminal program, but occurs the same problem again.I need any solution to this pro...
Hi person,You can use the ASA as a DHCP relay, and the configuration is very simple. You must define the IP address of the your DHCP server and enable the relay on the interface. Other parameters are optional.Although you can use the relay, my recome...
Hi person,Regarding this PC can connect to other machines in your internal network but cannot connect with Internet, you must be sure that all parameters obtained through DHCP will be configured mannualy in the host, like ip address, dns servers, de...
Hi person,This forum is focused in to discuss questions about PCI Compliance. By this way, post the same question in the VPN Forum (http://forum.cisco.com/eforum/servlet/NetProf?page=Virtual_Private_Networks_discussion), when i will to answer with pl...
Hi person,Your access-list is not correctly organized.The basic idea for all ACL is the following:- Evaluate rules by rule, of top at down.- When a rule match the packet under analysis, take the action of this rules.- No more rules will be evaluated ...
Hi person,Commonly the Cisco ACS is dont run over the default port for HTTPS (443). In this case, you must use the following URL to access remotely (Web Admin) your Cisco ACS:https://address_of_the_ACS:2002Try this!Regards,BHS
