Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have some corporate customers that purchase guaranteed bandwidth. What we want is to take benefit of this pipe of bandwidth to provide shared bandwidth to others.Does the config below will achieve this goal?policy-map INTERFACE_POLICY class ...
Hello,I am running a AS5400XM as a voip gateway connected to VOIP wholesale providers. The voice switch behind this gw basically define the voice trunk per IP source which is not very flexible.I found a way to have multiple SIP trunk between the AS54...
Hello,I would like to add redundancy to a design but I am stuck with Cisco HSRP/VRRP limitation (virtual IP should be in the same subnet than the physical IPs).Basically, I provide to my customers, a /29 public subnet, 5 available hosts as 1 IP in th...
Hello,We have been facing performance issue on a new setup with NAT and OSPF.Basically, the two routers in the middle are NATing the private customer subnet with 2 pools of public IP (one on each router). The outbound traffic is loadbalanced between ...
Hello,I am having an issue with a M2PA linkset going down like 10 times a day for a period of 20s. I believe this can be fixed by tuning the timeouts but I am unable to find the good commands.This is the log:Jan 24 14:14:43.814 GMT: %CS7M2PA-3-DESTAD...
I am not sure how it can work with NAT. My customers are in the /29 public subnet and will point the gateway to a public IP. Then on the GW I configure three private addresses NATed to a public one ?I think the public GW will not be reachable from th...
Actually with HSRP in GNS3, it simply does not work. When I configure a virtual IP that does not belong to the same subnet as the real interface, there is no hello packet sent between the routers. The standby mode is not working.
