Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,I am wondering how would we extend a FCoE VLAN/VSAN to remote DC.Can we use the extended VLAN from OTV and use it for FCoE or FCIP to span the SAN using N5K?I appreciate if someone let me know what are the options to extend the VSAN/SAN acr...
Hello Guys,Can someone confirm if the M2 linecard will support OTV or not, I just cant find relevant information about this on Cisco website.Best RegardsMohammed Khair
Hello Guys,I found an interesting vPath behavior in VSG with ASA 1000v deployement on ESXi cluster. ASA 1000v have 2 interfaces only for data (Inside and Outside).When you want to enable the vPath for the ASA, you should apply vservice node type asa ...
Dear all,I am trying to figure out how to configure 2x IPS 4270 in promiscous mode with Cisco 6509 VSS:I have attached the LLD core datacenter design including the IPS physical placement in my network.The following points are my concerns in this desi...
Hi Guys,I am trying to get the first 15 lines of my interfaces output through EEM.I have made this script to do that task, but the problem with it is that this script will view only the first 5 lines correctly, then it duplicate the rest of the lines...
Hi Surya,Thank you for your reply.Can you please send me a link of Cisco Nexus 5000 FCIP implementation. Mohammed Khair Khomakho CCIE Routing and Switching #26682
The loop would occure if someone sends a packet to an unknown IP address or MAC address for VLAN 505 or 504.Each VLAN will try to send lookup to all the ports in the respective VLAN 504 or 505 (and the loop starts, since VLAN 504 will flood to all po...
You should never use burst value 0 because this means you will filter every hit (syn, acl-drop etc).I'll give you a sample example here that I use in production:no threat-detection rate syn-attack rate-interval 600 average-rate 100 burst-rate 200 ...
